Use these stainless steel fasteners for corrosion - resistant mounting of your seat pedestals. Nut and Bolt Kit sold per 6. 1-1/2" screws sold per 6. Available: 1-1/2" screws, Nut and Bolt Kit.
Use these stainless steel fasteners for corrosion - resistant mounting of your seat pedestals. Nut and Bolt Kit sold per 6. 1-1/2" screws sold per 6. Available: 1-1/2" screws, Nut and Bolt Kit.
Average Customer Rating:
2.4 out of 5
2 of 5 (40%) customers would recommend this product to a friend.
Customer Reviews for Cabela's Stainless Steel Pedestal Mounting Hardware
Overall Rating:
3
out of 5
Needs more detail in discription,June 17, 2009
By illiniron2from Illinois
"Good quality product, but needs more info on size(length and diameter) of bolts. Are a little short to go through 3/4 plywood(will work barely!)"
Would you recommend this product to a friend? No
Review 2 for Cabela's Stainless Steel Pedestal Mounting Hardware
Overall Rating:
1
out of 5
Mounting Hardware,May 27, 2009
By BowHunter34from Red Wing, MN
"Waste of money, the screws were not even long enough to use on a standard boat floor. I had to go buy other bolts."
Would you recommend this product to a friend? No
Review 3 for Cabela's Stainless Steel Pedestal Mounting Hardware
Overall Rating:
1
out of 5
Not sure what mounts these fit.... BUT,April 12, 2009
By Suskyfisher
"I would have what I would call regular mounts. Stainless steel 7x7 mounts with a 3/4 inch hole for the seat pin.
This hardware isn't even close to fitting, its way too large. Now just sitting in my garage."
Would you recommend this product to a friend? No
Review 4 for Cabela's Stainless Steel Pedestal Mounting Hardware
Overall Rating:
4
out of 5
Stainless Mounting Hardware,April 7, 2008
By Senkoclubfrom Kentucky
"Bolts are a little short but fit ok in my boat. I ended up getting some wood grip nuts for the underside because they are easier to install. There isn't any way to hold the nuts in place while installing the base. The wood grips bury into the wood on the underside of the plywood and stay in place when installing the bolts. Drill the holes to match the base; hold a nut under the hole; install a short bolt and tighten it to insert the barbs on the nut into the wood; repeat it for each nut; then install the base and tighten the bolts. It works great. My recommendation would be for Cabela's to change the nuts to a wood grip type of nut."
Would you recommend this product to a friend? Yes
Review 5 for Cabela's Stainless Steel Pedestal Mounting Hardware
Overall Rating:
3
out of 5
Wrong Size Hardware,July 31, 2007
By 2fishfrom Chesnee, SC
"The bolts that came in the hardware kit were too big for the holes in the pedestal and they were too short to go through the pedestal and 3/4" plywood floor."
