| Overall Rating: |
|
5
out of 5
|
Winchester does it again,
November 19, 2009
By RetiredUSMC07
from Jacksonville, NC
|
"As always, winchester provides a product unmatched by anyone else. I have shot and reloaded several other name brands, and I have yet to find anyone that can match the quality and percision of winchester. I reciever my unprimed brass in a timely manner from cabelas and after checking over my order, I was able to start reloading almost immediately. Thanks again to Cabelas for carring top of the line reloading supplies."
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 2 for Winchester® Unprimed Rifle Brass - Per 100
| Overall Rating: |
|
5
out of 5
|
Winchester Brass,
October 27, 2009
By BigCal
from Wyoming, PA
|
"Very consistent quality. Never had a problem."
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 3 for Winchester® Unprimed Rifle Brass - Per 100
| Overall Rating: |
|
5
out of 5
|
Winchester Brass,
October 12, 2009
By SuperReloader
from Tyler, TX
|
"Winchester Brass is the best as far as my experience."
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 4 for Winchester® Unprimed Rifle Brass - Per 100
| Overall Rating: |
|
5
out of 5
|
brass,
October 7, 2009
By jupitor
from washington
|
"very good product easy to use luckey cabelas carries a good line of reloading supplies"
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 5 for Winchester® Unprimed Rifle Brass - Per 100
| Overall Rating: |
|
3
out of 5
|
win brass,
September 18, 2009
By DEC
from OKC, OK
|
"normally use Remington brass but could not get in 300WSM. will work well enough but Rem is just as good and cost less"
|
|
Would you recommend this product to a friend?
No
|
|
Review 6 for Winchester® Unprimed Rifle Brass - Per 100
| Overall Rating: |
|
5
out of 5
|
Good Brass,
September 10, 2009
By Chymist
from Afton, OK
|
"As a benchrest shooter I almost always use Remington brass in matches because of its consistancy [uniformity]. Even so, Hours are spent screening, preparing and working over 100 or so cases of which around 25-50 survive as good enough to use.
However, for hunting I prefer Winchester brass because it is harder and springer than most other brass and it's case volume is larger than other brands [brass is thinner]. This means that the brass holds up better under field conditions and ensures that when handbook information is strictly followed [never, ever, overload] the cartridge will not generate too much pressure on hot days. Under field conditions the notion of benchrest accuracy is necessary is just plain foolish. Safety and suitability rule hunting.
I also have had fine experience with the new Nosler brass."
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 7 for Winchester® Unprimed Rifle Brass - Per 100
| Overall Rating: |
|
5
out of 5
|
winchester brass,
September 10, 2009
By BH
from Lolo, MT
|
"shipped when promessed. price was good"
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 8 for Winchester® Unprimed Rifle Brass - Per 100
| Overall Rating: |
|
5
out of 5
|
WINCHESTER UNPRIMED BRASS,
August 25, 2009
By jc10
from kingsport tn.
|
"WELL FORMED BRASS."
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 9 for Winchester® Unprimed Rifle Brass - Per 100
| Overall Rating: |
|
4
out of 5
|
winchester brass,
August 16, 2009
By garywh
from danville va.
|
"been using winchester brass for 20+years.like it better than most other brands that i can afford. do have 1 or 2 casings per bag with bad necks. looks like ripped by machine when ejecting them."
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 10 for Winchester® Unprimed Rifle Brass - Per 100
| Overall Rating: |
|
5
out of 5
|
brass,
August 4, 2009
By gunnydude
from frederick md.
|
"I do not know how to review rifle brass. It was recieved in good shape and does exactly what it was intended to do"
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 11 for Winchester® Unprimed Rifle Brass - Per 100
| Overall Rating: |
|
5
out of 5
|
Winchester Unprimed Rifle Brass 300 WSM,
July 23, 2009
By mafufa
from Mentone, California
|
"Winchester brass is the easiest to prepare to load, one trip through the resizer die and it was ready to load. I deburred the inside primer hole and loaded 50 rounds. After fireing the ammo I found that they did not strech and did not need to be trimmed for the next reload. I shot excellent groups with the first load and antisipate the same with the next now that they are fire formed. Over all I would highly reccommend Winchester brass to any reloader."
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 12 for Winchester® Unprimed Rifle Brass - Per 100
| Overall Rating: |
|
4
out of 5
|
Brass,
July 20, 2009
By GRMIXOYE
from Waynesboro, VA
|
"Fine for hunting...only had one that was defective...softer than other name brands but serves it purpose at a very reasonable price."
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 13 for Winchester® Unprimed Rifle Brass - Per 100
| Overall Rating: |
|
5
out of 5
|
rifle brass,
July 14, 2009
By okdavid40
from Prague , Oklahoma
|
"Good quality clean brass."
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 14 for Winchester® Unprimed Rifle Brass - Per 100
| Overall Rating: |
|
5
out of 5
|
re-load 300 savage,
July 14, 2009
By freddy300
from selbyville de.
|
"the bass was easy to load from the primer to the bullet. all of 100 in good shap . shot well saved a lot."
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 15 for Winchester® Unprimed Rifle Brass - Per 100
| Overall Rating: |
|
5
out of 5
|
Brass forms just fine.,
July 7, 2009
By TeknysGold
from Idaho
|
"I purchased 308 Win brass to run through dies for a 338 Federal. With a little lube and one pass, I could continue reloading and they shot great. I've not reloaded but one time yet so I don't know how many reloads are there with case throat being stretched out to .338"
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 16 for Winchester® Unprimed Rifle Brass - Per 100
| Overall Rating: |
|
1
out of 5
|
270wsm Winchester's unprimed brass,
June 30, 2009
By FTMhunter
from Winnemucca, Nevada
|
"I have been reloading over 25 years. The recent 200 rounds of 270WSM Brass I received had many deformities, 1st approximately 20% were severely over-length .030 to .075. approximately 5% would not fit into the shell plate and 4 had severe neck deformities. If you need brass and decide to use Winchester's, be sure to examine closely before reloading."
|
|
Would you recommend this product to a friend?
No
|
|
Review 17 for Winchester® Unprimed Rifle Brass - Per 100
| Overall Rating: |
|
5
out of 5
|
Great Brass,
June 22, 2009
By RobertK79
from Colroado
|
"I received 100 pieces of Winchester Brass and am very pleased with the quality of the brass and the condition in which it arrived. None of the brass was damaged in any way and all is bright and shiny inside and out. All 100 pieces of brass were with in .005 of each other. Over all I am very pleased with the brass and plan to order much more."
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 18 for Winchester® Unprimed Rifle Brass - Per 100
| Overall Rating: |
|
4
out of 5
|
Win 308 Brass,
June 16, 2009
By CuseCat04
from Syracuse, NY
|
"This brass came as expected. I have only made it through 50 cases so far but they are of acceptable quality."
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 19 for Winchester® Unprimed Rifle Brass - Per 100
| Overall Rating: |
|
5
out of 5
|
2ndhandsip,
May 11, 2009
By 2ndhandsip
from washington state
|
"these these are better than any use shells i have used"
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 20 for Winchester® Unprimed Rifle Brass - Per 100
| Overall Rating: |
|
5
out of 5
|
Excellent Buy,
April 24, 2009
By AKAE
from Kenai, AK
|
"I was extremely pleased with this brass. In the two bags I bought, only two shells were found to have minor dents; nothing that prevented using them. I always mic, size and trim my brass before even the first loading. This brass was as consistent as the match brass I've purchased in the past. The only flaw I noted was that some of the case mouths would need reaming to remove the roughness. Loads performed as well with these, as with the match brass- less than 1 MOA."
|
|
Would you recommend this product to a friend?
Yes
|
|
