| Overall Rating: |
|
1
out of 5
|
winchester model 94 rifle stocks,
June 16, 2009
By happyhunters
from Pennsylvania
|
"I purchased 2 replacement butt stocks for a couple of Winchester 94's. The wood was very nice, BUT, That was it. The rear of the stock was over 1/4" thicker than originals. It was also cut straight so the origional curved steel butt plate could not be used. They were not milled deep enough so more work would be needed for the receiver tangs to fit. Unless you did all the work yourself, it would cost more than the initial price to have them fitted. This is the first time I ever returned any items to Cabela's. I was surprised they would handle anything so wrong."
|
|
Would you recommend this product to a friend?
No
|
|
Review 2 for Cabela's Walnut Rifle and Shotgun Stocks
| Overall Rating: |
|
1
out of 5
|
shotgun stock,
May 4, 2009
By moedan
|
"the machining was OK fit to tang was good but would take a lot of work to fit to older browning A5
it would be better if no finish was applied so you could put your own finish on the wood it would be verry dificult to finish over the oil that is on it.
product was returned"
|
|
Would you recommend this product to a friend?
No
|
|
Review 3 for Cabela's Walnut Rifle and Shotgun Stocks
| Overall Rating: |
|
4
out of 5
|
Walnut ShotGun Stocks,
March 17, 2009
By NCWHITETAIL
from North Carolina
|
"Great Looking Stock, goes together well."
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 4 for Cabela's Walnut Rifle and Shotgun Stocks
| Overall Rating: |
|
5
out of 5
|
like it!!!!!,
February 18, 2009
By minutemanmack
from WESTERN MAINE............
|
"THIS IS THE 3rd STOCK I HAVE BOUGHT IN THE LAST FEW YEARS.. PEOPLE LIKE THE WOOD GRAIN!!!!!!!!!!!!AN OLD GUNSMITH.............."
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 5 for Cabela's Walnut Rifle and Shotgun Stocks
| Overall Rating: |
|
4
out of 5
|
cabelas walnut rifle stocks,
February 9, 2009
By dutchman99
from pa.hunter
|
"v ery good quality. fair price."
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 6 for Cabela's Walnut Rifle and Shotgun Stocks
| Overall Rating: |
|
4
out of 5
|
Stock review,
January 27, 2009
By Bamafan1
|
"Excellent product. Very little work required to fit."
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 7 for Cabela's Walnut Rifle and Shotgun Stocks
| Overall Rating: |
|
5
out of 5
|
replacement stock for a savage 99,
December 3, 2008
By Pipelinedriver
from Wheatland , Wy.
|
"This stock was to replace the factory stock that had been
cut off.
The wood is a very nice walnut and I will add that I bought
the fore arm also .The two pieces were a very good match.
There only minor fitting needed.
Great item."
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 8 for Cabela's Walnut Rifle and Shotgun Stocks
| Overall Rating: |
|
1
out of 5
|
Winchester 12 Replacement Stock,
November 28, 2008
By TallahasseeFrank
from Tallahassee Florida-wildlife biologist and hunter
|
"I ordered the Winchester 12 replacement stock for my Winchester Model 12 Shotgun.
I was impressed with the appearance of the stock. It has a rough (i.e., not varnished) finish similar to that found on the early Model 12s. Its external cut and dimensions were virtually identical to the original. I thought I was pleased at this point.
Then I tried to attach the replacement stock to the shotgun. After removing the old stock, I fit the replacement stock to the gun. Try as I might, I could not get the stock bolt to thread into the the threaded bolt receptacle that is an extension of the shotgun's receiver. I worked at it for well over an hour with no luck.
In frustration, I took the gun and the replacement stock to my gunsmith for fitting. He was also quite frustrated with his efforts to get the stock bolt to engage the threaded bolt receptacle. Finally, he determined that the recessed hole pre-bored in the replacement stock to recieve the stock bolt was not bored deep enough to allow the bolt threads to reach and engage the threaded bolt receptacle on the gun's receiver. He extended the depth of the pre-bored hole, and sucessfully bolted the stock to the gun's action. It cost me $39.00 (plus tax) to get the stock to work on the gun it was designed for, and that sounds like a bargain in terms of the time the gunsmith spent on figuring out the problem"
|
|
Would you recommend this product to a friend?
No
|
|
Review 9 for Cabela's Walnut Rifle and Shotgun Stocks
| Overall Rating: |
|
5
out of 5
|
Perfect,
October 6, 2008
By sknue
from Petal, MS
|
"I looked everywhere for a stock for my Revelation 12 gauge which is really a Savage Model 94. Finally found one at Cabelas. I was skeptical t was the right one, but it was."
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 10 for Cabela's Walnut Rifle and Shotgun Stocks
| Overall Rating: |
|
1
out of 5
|
Does not fit right,
April 16, 2008
By Michael85
from CA
|
"I ordered the Savage 99 stock and it did not fit correctly. I had to sand to fit which resulted in me having to refinish the stock once it was done. Once I got the stock to slide on, the hole for the stock screw was too long, so the screw didn't reach the reciever so I could not fit it without sanding even more. Not for beginners like I was. It took days to get it to fit right. The stock I was sent was a monte carlo which I am not a fan of, so if ordering a Savage 99 stock be prepared for that."
|
|
Would you recommend this product to a friend?
No
|
|
Review 11 for Cabela's Walnut Rifle and Shotgun Stocks
| Overall Rating: |
|
1
out of 5
|
Winchester 94 post 64 stock,
March 31, 2008
By biggggJimmy
from Arizona
|
"Stock has a fair finish at best ,it will take a lot of work to get it to fit a rifle,It is not for a beginner.this stock should be fit by a professional"
|
|
Would you recommend this product to a friend?
No
|
|
Review 12 for Cabela's Walnut Rifle and Shotgun Stocks
| Overall Rating: |
|
4
out of 5
|
zz,
March 7, 2008
By Brushguy
|
"I had a little triming to get the new replacement stock to fit properly. The finish was good. Over all no problems."
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 13 for Cabela's Walnut Rifle and Shotgun Stocks
| Overall Rating: |
|
1
out of 5
|
Cabela's Walnut Mauser 98 Stock,
February 21, 2008
By BigCoop
from Jacksonville,Florida
|
"The overall quality of the finish was disappointing. There were a lot of rough areas and spots that could use a little more shaping. The "rubbed oil finish" was nearly non-existant. I had to do a lot of work on what should have been a drop in part. Don't buy this one unless you paid attention in shop class."
|
|
Would you recommend this product to a friend?
No
|
|
Review 14 for Cabela's Walnut Rifle and Shotgun Stocks
| Overall Rating: |
|
5
out of 5
|
easy fit,
February 7, 2008
By jmayks
from S.E. Ks.
|
"Excellent grain in wood little work needed to fit gun."
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 15 for Cabela's Walnut Rifle and Shotgun Stocks
| Overall Rating: |
|
1
out of 5
|
GARBAGE,
January 15, 2008
By EMORE
|
"The Stock will not fit properly with out major work, not
worth the money."
|
|
Would you recommend this product to a friend?
No
|
|
Review 16 for Cabela's Walnut Rifle and Shotgun Stocks
| Overall Rating: |
|
5
out of 5
|
Excellent value,
August 1, 2007
By Augdog
from Seattle, WA
|
"For the price, these are an excellent bargain. When you compare what you get with similar offerings at the same finish level, the Cabela's product shines.
Still, be prepared to do some final fitting and inletting, and to add desirable extras such as sling swivels, a recoil pad, etc."
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 17 for Cabela's Walnut Rifle and Shotgun Stocks
| Overall Rating: |
|
4
out of 5
|
Rambo,
July 30, 2007
By Rambo1
from Mn
|
"This rife stock worked out great, nice looking wood with very little fitting to do. The quality of the wood was nice for ordering off the inter-net and not seeing or touching it first I was very happy with what I got...."
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 18 for Cabela's Walnut Rifle and Shotgun Stocks
| Overall Rating: |
|
5
out of 5
|
EXCELLENT,
July 23, 2007
By fathertime
from EL PASO,TEXAS
|
"I BOUGHT THIS RIFLE STOCK AS A GIFT FOR MY DAD.I DO NOT KNOW IF IT WILL FIT HIS GUN BUT IT LOOKS JUST LIKE IT WAS ADVERTISED,AND IT MATCHES THE BROKEN STOCK I SAW,SO I AM SURE IT WILL FIT ."
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 19 for Cabela's Walnut Rifle and Shotgun Stocks
| Overall Rating: |
|
5
out of 5
|
cabela's walnut rifle stock,
June 4, 2007
By PhillipJon
|
"It is a good looking stock. It required very little work to finish it. After coating it with some true oil it looks great."
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 20 for Cabela's Walnut Rifle and Shotgun Stocks
| Overall Rating: |
|
5
out of 5
|
walnutstocks,
November 20, 2006
By gridgunner21
from Oklahoma
|
"they take some fitting, but they will fit."
|
|
Would you recommend this product to a friend?
Yes
|
|
