| Overall Rating: |
|
3
out of 5
|
Needs work,
September 29, 2008
By BCFred
from Asheville, NC
|
"While they do ream out the holes, a great deal of effort is required to remove the material in pre-made handles. For individual cork rings, the should work great."
|
|
Would you recommend this product to a friend?
No
|
|
Review 2 for Cabela's Cork Reamers
| Overall Rating: |
|
2
out of 5
|
cork reamer,
July 29, 2008
By newrodmaker
from oregon
|
"I found the small reamer too large and with too much taper to use. I wanted to enlarge a flyrod grip to .40 on rod end and .410 reel end. The reamers tip is .335 and 6 inches down is .410. ( 5 inches is .40 ) Five to six inches of reamer is not enough to work with. The reamer is a half inch where it runs out of grit and has 13 inches of abrasive. The sku on the package is correct but also has 1/4 on it. Would have been nice if the catalog has the demensions other than sml, med and lg...."
|
|
Would you recommend this product to a friend?
No
|
|
Review 3 for Cabela's Cork Reamers
| Overall Rating: |
|
3
out of 5
|
Could be better,
July 2, 2008
By Hogw1ld
from Montana
|
"This reamer is at best average! It reams cork decent. However the reaming medium that is bonded to the handle does not stay attached very well, I built two rods with 2 cork handles and the top 1.5 inches of the reamer has lost the medium. Better of spending the same amount of money on a round file at the local hardware store."
|
|
Would you recommend this product to a friend?
No
|
|
Review 4 for Cabela's Cork Reamers
| Overall Rating: |
|
3
out of 5
|
Cheap and do their job,
April 15, 2008
By zuren
from CT
|
"I don't know how many rods I'm going to build so I opted for the cheapest reamers I could find. I have the Medium and Large reamers and they did there job. The only thing I would change is the handle area. I had to remove a lot of material on one grip so the reamer was meeting a lot of resistance, to the point that I was getting blisters on my hand. Either my technique was wrong, my hands aren't tough enough or just hanging onto the smooth blank of the reamer doesn't work well in that situation. My solution was to wrap a rag around the grit just in front of the handle area to have all the comfortable torque I could apply."
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 5 for Cabela's Cork Reamers
| Overall Rating: |
|
1
out of 5
|
poor,
March 7, 2008
By Pittguy
from Pittsburgh
|
"Small sized one broke the first time I used it."
|
|
Would you recommend this product to a friend?
No
|
|
Review 6 for Cabela's Cork Reamers
| Overall Rating: |
|
4
out of 5
|
Cabela's Cork Reamers,
January 16, 2008
By cavebear
from Phelan, CA
|
"works good. holds together. will buy again"
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 7 for Cabela's Cork Reamers
| Overall Rating: |
|
5
out of 5
|
CABELA'S ALWAYS THE BEST IN QUALITY,
January 15, 2008
By RANDLOPH
from HENDERSON, NEVADA
|
"THEY
WORK AS WELL AS THE MORE EXPENSIVE BRAND.....I USED MY WITH A SMALL POWER
DRILL AND THEY CUT THE CORK AND FOAM LIKE NO TOMORROW......GREAT TOOL"
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 8 for Cabela's Cork Reamers
| Overall Rating: |
|
4
out of 5
|
Cork Reamers,
January 7, 2008
By BAKEOH1
from BAKERSFIELD, CA
|
"Good product. I will buy them again when these wear out. They could use a smaller one for starting out on smaller handles."
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 9 for Cabela's Cork Reamers
| Overall Rating: |
|
3
out of 5
|
Good for a workout.,
January 7, 2008
By Mudflap
from Columbus, Ohio-Go Bucks
|
"A little extra muscle is needed to use this product. OK for occasional builder. I wouldnt want to use this reamer all day, it just requires a lot of muscle."
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 10 for Cabela's Cork Reamers
| Overall Rating: |
|
5
out of 5
|
Cabela Cork Reamers,
November 13, 2007
By Dryfly
from Missouri
|
"Works great almost fool proof,great product"
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 11 for Cabela's Cork Reamers
| Overall Rating: |
|
4
out of 5
|
Cabela's Cork Reamers,
August 7, 2007
By Flifisherman
from Fort Worth, TX
|
"These reamers are very handy when fitting cork handles to a rod.They work quite well, except when you make the mistake I made of trying to use it with a drill to speed up the process. The reamer is not made to be used that way,and it collapsed. I have since ordered another, and put the drill away. Good Fishing"
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 12 for Cabela's Cork Reamers
| Overall Rating: |
|
4
out of 5
|
WORKS GOOD LAST A LONG TIME!,
April 18, 2007
By DIMROD
from WASHINGTON
|
"AMAZINGLY EASY TO USE AND WORKS 100% BETTER THAN A SHORT HANDLED RASP."
|
|
Would you recommend this product to a friend?
Yes
|
|
Review 13 for Cabela's Cork Reamers
| Overall Rating: |
|
4
out of 5
|
Cabela's Cork Reamers,
April 16, 2007
By DonJ
from Loveland. CO
|
"Better than the wood rasp I was using."
|
|
Would you recommend this product to a friend?
Yes
|
|
