The Forster Hand-Held Neck Turner provides extreme accuracy through consistent wall thickness around the case neck. This
durable, smooth-cutting, carbide tool is precision ground with special angles and reliefs designed specifically for precise neck turning. The unique cutter approach angles allow turning up to the case shoulder for superior handload performance. The turner is easily adjusted to a half-thousandth of an inch in either direction with a marked micrometer adjustment knob.
The Forster Hand-Held Neck Turner provides extreme accuracy through consistent wall thickness around the case neck. This durable, smooth-cutting, carbide tool is precision ground with special angles and reliefs designed specifically for precise neck turning. The unique cutter approach angles allow turning up to the case shoulder for superior handload performance. The turner is easily adjusted to a half-thousandth of an inch in either direction with a marked micrometer adjustment knob.
Average Customer Rating:
3.8 out of 5
3 of 4 (75%) customers would recommend this product to a friend.
Customer Reviews for Forster Hand-Held Neck Turner
Review 1 for Forster Hand-Held Neck Turner
Overall Rating:
2
out of 5
forster shell holder,October 19, 2009
By rick2800from ky
"the trimmer works great i do like my rcbs better . the shell holder slips very bad on the case i bought another rcbs holder and problem solved."
Would you recommend this product to a friend? No
Share this Review:
Review 2 for Forster Hand-Held Neck Turner
Overall Rating:
3
out of 5
Forster hand-held outside neck turner,May 11, 2009
By Discriminator
"The product works fine except for:
The ribbed, plastic knob used to tighten the base of brass placed in the holder is to small to allow adequate tightening. The grooved surface is sharp and, unless one has calloused hands, can be painful and even raise blisters for those who are stubborn.. I cut the knob off, crafted one two inches long from hardwood and epoxied it in place. The smallest set-screw used to retain the carbide cutter was too soft. It rounded out the third time I re-set it and was replaced by a slightly longer one from the hardware store. The case-neck mandrels available are spot on. I would recommend with the proviso that one make the above (cheap) fixes."
Would you recommend this product to a friend? Yes
Share this Review:
Review 3 for Forster Hand-Held Neck Turner
Overall Rating:
5
out of 5
Hand Held neck turner,September 13, 2007
By campcook50from Northern California
"It took me a few minutes to get the hang of this tool, but once I started, it was a breeze! It was able to just shave .001 from the necks!
When my hands got a little fatigued, I chucked up the cases in my cordless drill, THAT made neck turning a snap!
Get one, you won't be sorry!
Happy Reloading!
Campcook50"
Would you recommend this product to a friend? Yes
Share this Review:
Review 4 for Forster Hand-Held Neck Turner
Overall Rating:
5
out of 5
Good product,August 6, 2007
By Snipomaniacfrom Murrieta, Ca
"Very precise and the carbide cutter is very sharp."
