These Roller Bunk Brackets are die-formed from heavy-gauge steel plate for long life. Four brackets required
for installation of each pair of roller bunks. Made in USA. Per each. Available: Galvanized.
These Roller Bunk Brackets are die-formed from heavy-gauge steel plate for long life. Four brackets required for installation of each pair of roller bunks. Made in USA. Per each. Available: Galvanized.
Average Customer Rating:
2.3 out of 5
3 of 4 (75%) customers would recommend this product to a friend.
Customer Reviews for Roller Bunk Bracket
Overall Rating:
1
out of 5
roller bunk brackets,June 23, 2008
By supermanDanfrom Tallahassee, FL
"These brackets did not line up to the holes on my trailer. The existing brackets had only one verticle slot for the bolts to fit in to bolt to the trailer. The roller bunk brackets have 2 verticle slots to fit bolts into to bolt to the trailer and they were spaced differently then the holes on my trailer. i had to drill the swivel part of the bracket off and use that piece with my existing brackets. So, the moral of the story is, that if you are going to use these brackets, make sure that they will fit the holes on your trailer."
Would you recommend this product to a friend? No
Review 2 for Roller Bunk Bracket
Overall Rating:
3
out of 5
roller bunk bracket,June 2, 2008
By doxxiefrom Guthrie, Ok
"There were no bolts or other attaching devices with the brackets. I did not use them and now have them setting in my garage collecting dust. I have no way to return them that I know of. Appear to be a useful product but you better know exactly what you are getting before you order. Make sure there is an adequate picture of the product."
Would you recommend this product to a friend? Yes
Review 3 for Roller Bunk Bracket
Overall Rating:
3
out of 5
Bunk Brackets,July 24, 2007
By danyb3from Sudbury,On.Ca
"I had to remove the top parts of the brackets by drilling out the pin and putting them on my old brackets,just to lower my roller beds to touch my center rollers.They don't pivot anymore but my boat sits nicely on the beds and centered great.I had an EasyHaul trailer,but if I would have had a different one I might not of had to adapt these brackets.I keep the other parts in case I change trailers later.All in all good brackets I didn't have to send them back and they did do the job.."
Would you recommend this product to a friend? Yes
Review 4 for Roller Bunk Bracket
Overall Rating:
2
out of 5
Roller Bunk Bracket,July 3, 2007
By PoorManfrom Illinois
"Had to modify the bracket so I could clamp it to the frame. Problem was the bracket was too wide. Different lengths need to be available, as the current bracket extends down too far. Can not shorten as it weaken the bracket."
