Wood Bow Slat Sockets come in pairs. One pair is needed for each bow. Screws
are not included. Sockets are 2" in length, 1/2" wide and 1/2" in height.
Mounting hole diameter is 3/16."
Wood Bow Slat Sockets come in pairs. One pair is needed for each bow. Screws are not included. Sockets are 2" in length, 1/2" wide and 1/2" in height. Mounting hole diameter is 3/16."
Average Customer Rating:
5 out of 5
3 of 3 (100%) customers would recommend this product to a friend.
Customer Reviews for Wood Bow Boat Cover Support Slat Sockets
Overall Rating:
5
out of 5
SATISFACTION,July 8, 2009
By HAHA
"AGAIN,AS ORDERED AS ADVERTISED"
Would you recommend this product to a friend? Yes
Review 2 for Wood Bow Boat Cover Support Slat Sockets
Overall Rating:
5
out of 5
Wood Bow Slat Sockets,February 1, 2008
By JerseyShorefrom Bayville, NJ
"I purchased these sockets and used them with the fiberglass bows that I used to hold my cover up over the winter. They worked out just fine and I have no problems with water or snow sagging my cover in and collecting."
Would you recommend this product to a friend? Yes
Review 3 for Wood Bow Boat Cover Support Slat Sockets
Overall Rating:
5
out of 5
Fibergalss Bows for Boat Covers,January 31, 2008
By tntargofrom Yuba City, CA
"These fiberglass bows work very well for supporting boat covers. I had only one supporting the main part of my boat cover, and water pooled just ahead of the bow. I added another bow between the existing one and the base of the windshield sides. Problem solved! Be sure to be very careful when you cut it to length. Not much you can do if you cut it too short. Leave it a little long, test fit it into the pockets and cut it little at a time until you get the arc you want. Also be careful when you saw it off. If you don't support it and carefully cut all the way through, the fiberglass will tear back. If it tears a little, just finish the cut and then glue the fibers back to the bow with some CA glue."
