TA larger capacity, minimal assembly and a life-long industrial motor make our spreader the envy of the market. Unlike
other spreaders that are limited by a specific weight capacity, our hopper will fit as much as the weight capacity of your
ATV rack will allow (up to 15 gallons). Assembly is quick and easy. Just attach back plate to your ATV rack and connect
the motor wires to the motor. The high-torque motor has a longer life span and higher throw volume than comparable
spreaders. Plus, it won't slow when spreading heavier objects such as fertilizer or salt. The switch is completely sealed
for protection from the elements. A universal quick-disconnect interface allows you to attach or detach the spreader
without use of tools.
Made in USA.
Spreads seed and fertilizer well. I was able to do 4 food plots in 2 hours where it had taken all day in the past. Here are some changes you will want to do right out of the box: - Make a larger shield out of card board, plexiglas, etc. to keep materials off your atv/utv.
- Replace the "battery clamp" power connectors with a "cigarette lighter" style power tap that has a built in switch. Add your own SAE 2 pin connector.
- Not a top priority, but I made my own bracket using a good quality choke cable so I could reach and control the hopper chute while seated on my ATV. Not possible as configured from the factory.
I have had my spreader for two months have used it several times. It has worked as advertised. The only thing that is an concern is the size of the shield, it is too small so the seeds or fertilized are all over the atv.
Great spreader, large capacity, easy setup, looks durable and worked great during 1st use. Two minor issues: needs a larger splash guard (made mine out of cardboard from shipping box) and can clog if material is lumpy. However this is a awsome speader, made fertilizing my 5 arces a breeze....