Easily remove or install your bimini top without the hassle of screws or pins. This unique hinge quickly and securely
snaps into the base when setting up your top, then stays conveniently connected to the top when you decide to remove
it. Base mounts directly to the boat's surface, no cutouts are necessary for installation. Will mount to either a vertical or
horizontal surface. Swivels 360°. Corrosion-resistant stainless steel construction. Per each. Two required for
Bimini installation.
Available:
This product is outstanding! I have an open bow 20' Alumacraft. It came with the quick release system behind the windows. I purchased the second se and mounted them in front of the windows. This allows me to take my bimini with me in the case that I need it. I just lean it toward the bow and put on a bungi chord.
This product works great. To get from and to my dock I must go under a low bridge and had to unscrew and screw back my hing by hand. No longer do I struggle with this task! What took a few minutes per side now takes seconds.
just got these and install was a snap, only had to drill one hole and use one existing. they simply push down and easily release when time to go. might want to add a very small spacer between the boat and bracket, one side is a little harder to snap in and out but not enough for me to send back.